Posts Tagged ‘New Milford’

Common Furnace Problems: A Guide from Hillside

Monday, November 14th, 2011

When it comes to your Hillside home’s York furnace, you simply want it to work all of the time. But just like any other piece of equipment, your furnace will have problems from time to time. A few of these are relatively simple to fix on your own, but for the most part you’ll need to call in someone to take care of the repairs for you.

However, before you can do that, you’ll need to recognize that a problem exists at all. And the earlier you notice the warning signs, the better off you’ll be. It’s always better to get a furnace problem taken care of right away than to wait until your York furnace stops working completely.

It’s also good to remember that quite often the problems you’re having with your furnace are really originating with your thermostat. This is usually welcome news, as thermostats are much cheaper and easier to repair and replace than many other parts of your furnace. In fact, even if your York furnace isn’t working at all, it may only be the result of a faulty thermostat.

Another problem you may start to notice is that one part of your house is being warmed more than another part. When this happens, it can be a sign that there is something wrong with the furnace, but it may also be that the pressure in your duct system is not balanced properly. A simple rebalancing of this system can have your house heating evenly again in no time.

You may also realize that your furnace seems to be cycling on and off too often. When a furnace is working properly, it will come on for a considerable period of time and then shut off until the temperature in the house drops below the desired level. However, some problems can cause your furnace to complete many short cycles rather than fewer short ones.

If this is happening to your furnace, there are several possible causes. Something might be wrong with the blower on the furnace or the thermostat might not be feeding the furnace the correct information. Another possibility is that your furnace’s air filter is dirty or clogged.

While there are sometimes simple and straightforward solutions to these types of common furnace problems, it’s best to call in a York professional to have them take a look if you’re not sure where to start searching for a problem. In most cases you’ll need them to come out and make the necessary repairs anyway.

Tags: , , , , , , ,
Posted in Heating | Comments Off

To Zone or Not to Zone My Home Comfort: Some Advice From Hoboken

Monday, September 26th, 2011

There are a lot of decisions to make related to your Hoboken home comfort system. You must decide what type of York heating system you want, how you’ll implement York air conditioning, and then how to keep all of that heated and cooled air clean and healthy in your home.

On top of everything else, you have the option to implement zone control in your house to provide multiple comfort levels for each member of your family. York Zone Control Systems are growing rapidly in popularity because they allow home owners to enjoy an enhanced level of comfort throughout the day, while not negatively impacting any one person.

For example, if it’s chilly outside and you need to turn your heater on, that doesn’t mean everyone in the house wants the thermostat set to 72°F. There are a few reasons for this. You may be in the kitchen, working over the stove or doing dishes where there is plenty of heat to keep you warm. More warm air coming through vents or radiators isn’t going to make you comfortable.

The second floor of a home traditionally needs less heat because warm air on the first floor rises and fills that space. The same is true in the summer when cool air settles in lower floors. Having a zone control system allows you to set specific temperatures in each room which are then controlled by your home heating system. You can even turn off the heating and cooling in a specific room like your office or the attic if it will be empty for long periods of time.

Other Considerations

A zone control system is good for comfort, but also for the overall air quality of your home. Too much conditioned air moving through your ducts carries more allergens and contaminants into your home and causes your air quality system to work harder. Your ventilation system will be asked to work harder as well.

Ideally, a good home air quality system is designed to use as little conditioned air as possible to keep everyone comfortable. A zone control system does this very effectively. When talking to a York dealer about a new installation, check to find out about York programmable thermostats as well. These can make it easier to set and forget the temperature in rooms that are only used for a few hours each day.

Tags: , , , ,
Posted in Air Conditioning, Heating | Comments Off

Top 3 Upgrades for Your HVAC System: A Tip From Cranford

Friday, September 23rd, 2011

Your York HVAC system is a trusted part of your Cranford home’s comfort system. Without it you would be cold in the winter, hot in the summer, and breathing in contaminant laden air year round. So, it’s important that you install the best systems and subsystems available for your York HVAC system. Here are some options to keep in mind when looking for ways to get the most from your heating and cooling.

  • Humidity Control – In the winter, a good York humidifier is the way to go. Humidification allows your home to hold more heat, effectively increasing the efficiency of your heating system.
  • Air Filtration – Every air conditioning system and furnace comes with some form of air filtration, but is it enough? Standard filters are effective, but they are not always comprehensive. A good HEPA quality filter for your air handler and duct system will severely reduce the number of contaminants in your air supply and ensure that you and your family feel much better year round.
  • Air Quality Controls – Beyond air filtration, you can upgrade your air handler’s ability to remove pollutants with a dedicated York air cleaner and UV lights. These systems are installed in your air handler and/or ductwork to remove advanced pollutants like bacteria and mold and remove smaller particles including smoke, gas, and exhaust. Which system you need will depend on the level of contaminants in your home, so make sure you check with a contractor before choosing anything.

These upgrades are a great way to get more out of your HVAC system – in terms of both comfort and safety. Discuss your options with a contractor today to learn more.

Tags: , , , , ,
Posted in Indoor Air Quality | Comments Off